Important note: If you are addressing issues with the exterior of your home, please consult the Lakeport Design Standards and remember that you may have to seek approval from Reston Association’s Design Review Board.
Homes in Lakeport Cluster, which are now more than 30 years old, are unique in several ways. This checklist is designed with Lakeport homes in mind, and these suggestions may help to reduce major repairs in the future. If you think you have a problem, however, we urge you to seek advice from a licensed and insured contractor or other service professional.
Although the cluster’s landscaping contractor takes care of common areas, our own driveways, yards, and other areas are our responsibility. Residents should not dump what they collect into the wooded common areas. Instead, they should dispose of leaves and other debris (e.g., fallen branches, dead outdoor potted annuals) from yards, patios, driveways, decks, and entranceways by placing them in large compostable paper yard-waste bags available at home improvement stores and Costco. Pickup for yard waste is Thursdays.
- Turn off the valves of the water lines to outdoor spigots. Typically, the valves are located in the same room as the hot water heater. After turning off the water, open the outdoor spigot to drain the line so that there is no water in the line to freeze over the winter.
- Fire-retardant plywood roof sheathing must be replaced if the material degrades due to high attic temperatures, which can cause it to fail to retard the spread of fire.
- Check wood siding and trim for signs of splintering, deterioration, softness, green mildew, or other discoloration. These are indicative of potential wood damage. Replace damaged siding and trim following Cluster standards for material and color. In the case of mildew or discoloration, ask a home improvement provider to suggest the appropriate cleaner to preserve the wood.
- Gutters, particularly those that are beneath a tree, may experience two problems: In the fall especially, the gutters easily become clogged, and/or any time of year, the spikes that attach them to the house may be pulling away. When a gutter is not working properly, you’ll often see staining on the vertical wall below the gutter. Fixing the first problem is easy – have your gutters cleaned. Even if you don’t have a tree nearby and even if you have something like Gutter Helmet or a strainer screen over them, gutters can still fill up with cinders washed down from your shingles over time. Gutters that are not slanted properly toward the downspout can put a lot of weight on the gutter, leading to the second problem. If you see gutter spikes coming loose, you can just drive them back in, which may hold for a while. However, there’s a better, longer-term, inexpensive solution. Home Depot sells long gutter screws that can replace failing gutter spikes. They go through a ferrule (a sleeve that keeps the screw from compressing the gutter itself) and screw into the wood behind the gutter. These are far more secure in the long run.
- Homeowners should check and if necessary replace gasket/pressure regulators in bathtubs and showers (including the overflow) to avoid flooding from a leak.
- Be sure to replace or clean your HVAC filter regularly.
- Periodically remove screens and tighten the four Phillips screws for casement windows shown in the photo. This keeps windows operating well, especially if they don’t seem to close all the way from time to time.
Post a Comment